Author Topic: DEFINITION OF ACCELERATION  (Read 3531 times)

0 Members and 1 Guest are viewing this topic.

joe74ta

  • Top Fuel Pilot
  • *****
  • Posts: 1563
DEFINITION OF ACCELERATION
« on: May 31, 2010, 10:35:16 PM »
DEFINITION OF ACCELERATION

  One top fuel dragster 500 cubic inch Hemi engine makes more  
horsepower than the first 4 rows of stock cars at the Daytona 500.

 It takes just 15/100ths of a second for all 6,000+ horsepower of an  
NHRA Top Fuel dragster engine to reach the rear wheels.

 Under full throttle, a dragster engine consumes 1-1/2 gallons of  
nitro methane per second; a fully loaded 747 consumes jet fuel at  
the same rate with 25% less energy being produced.

         A stock Dodge Hemi V8 engine cannot produce enough power to  
drive the dragster's supercharger.

 With 3,000 CFM of air being rammed in by the supercharger on  
overdrive, the fuel mixture is compressed into a near-solid form  
before ignition.

        Cylinders run on the verge of hydraulic lock at full throttle.

 At the stoichiometric (stoichiometry: methodology and technology by  
which quantities of reactants and products in chemical reactions are  
determined) 1.7:1 air/fuel mixture of nitro methane, the flame front  
temperature measures 7,050 deg F.

 Nitro methane burns yellow... The spectacular white flame seen  
above the stacks at night is raw burning hydrogen, dissociated from  
atmospheric water vapor by the searing exhaust gases.

         Dual magnetos supply 44 amps to each spark plug. This is  
the output of an arc welder in each cylinder.

 Spark plug electrodes are totally consumed during a pass. After  
halfway, the engine is dieseling from compression, plus the glow of  
exhaust valves at 1,400 deg F. The engine can only be shut down by  
cutting the fuel flow.

 If spark momentarily fails early in the run, unburned nitro builds  
up in the affected cylinders and then explodes with sufficient force  
to blow cylinder heads off the block in pieces or split the block in  
half.

 In order to exceed 300 mph in 4. 5 seconds, dragsters must  
accelerate an average of over 4G's. In order to reach 200 mph (well  
before half-track), the launch acceleration approaches 8G's.

         Dragsters reach over 300 miles per hour before you have  
completed reading this sentence.

 Top fuel engines turn approximately 540 revolutions from light to  
light! Including the burnout, the engine must only survive 900  
revolutions under load.

         The redline is actually quite high at 9,500 rpm.

 Assuming all the equipment is paid off, the crew worked for free,  
and for once NOTHING BLOWS UP, each run costs an estimate $1,000.00  
per second.

 The current top fuel dragster elapsed time record is 4.428 seconds  
for the quarter mile (11/12/06, Tony Schumacher, at Pomona , CA ).  
The top speed record is 336.15 mph as measured over the last 66' of  
the run (05/25/05 Tony Schumacher, at Hebron , OH ).

         Putting all of this into perspective:

 You are driving the average $140,000 Lingenfelter 'twin-turbo'  
powered Corvette Z06. Over a mile up the road, a top fuel dragster  
is staged and ready to launch down a quarter mile strip as you pass.  
You have the advantage of a flying start. You run the 'Vette hard up  
through the gears and blast across the starting line and pass the  
dragster at an honest 200 mph. The 'tree' goes green for both of you  
at that moment.

 The dragster launches and starts after you. You keep your foot down  
hard, but you hear an incredibly brutal whine that sears your  
eardrums and within 3 seconds, the dragster catches and passes you.  
He beats you to the finish line, a quarter mile away from where you  
just passed him.

 Think about it, from a standing start, the dragster had spotted you  
200 mph and not only caught, but nearly blasted you off the road  
when he passed you within a mere 1,320 foot long race course.

         ...... and that my friend, is ACCELERATION!




<object width="640" height="505"><param name="movie" value="http://www.youtube.com/v/lew0nIS2PZk&hl=en_US&fs=1&"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/lew0nIS2PZk&hl=en_US&fs=1&" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="640" height="505"></embed></object>

cluxford

  • Guest
DEFINITION OF ACCELERATION
« Reply #1 on: June 01, 2010, 01:12:28 AM »
absolutely love it !

twodogs

  • Guest
DEFINITION OF ACCELERATION
« Reply #2 on: June 01, 2010, 07:16:15 PM »
:pat:  I blinked and missed the race , darn it darn it , sorry boss , he he  :pat:

peterp

  • Administrator
  • Speedster
  • *****
  • Posts: 156
  • Member
    • http://www.yourithelp.com.au
DEFINITION OF ACCELERATION
« Reply #3 on: June 01, 2010, 08:50:50 PM »
Wow, a bit faster than my Camry.  LOL.

Nice facts about dragsters, expensive too.

Oh well back to my riceburner, a bit cheaper to run.

peterp
You only need two tools in life - WD-40 and Duct Tape. If it doesn't move and should, use the WD-40. If it shouldn't move and does, use the Duct Tape.

 

Phone 02 9829 5072

Phone 0438 658 458

Phone 0432 136 333